Hot melt adhesive gear flowmeter
 

Micro gear flow meters are widely used in the hot melt adhesive dispensing industry, tire dispensing industry, stretching film, packaging box/bag dispensing industry,
and so on. Tire dispensing and packaging box/bag dispensing are typical applications used to detect the dispensing frequency of hot melt adhesive machines
 

Medium: Hot melt adhesive (high temperature, high viscosity, low flow rate)
 

Due to the high temperature of hot melt adhesive, it is difficult to accurately determine the amount of adhesive released, detect the amount of adhesive released each
time, and check whether the pipeline is blocked or not; If the pipeline is blocked without glue, and there is no signal prompt without installing the flow meter, it will not
be detected.
 

By using our flow meter, we can not only detect whether there is glue produced, but also how much glue has been detected. We strictly control the amount of glue applied
to each product to avoid too little or too much. If there is no signal, it can also detect whether the pipeline is flowing. This can effectively avoid the problem of not being
glued and greatly reduce the scrap rate.

 

If you would like to know the specific selection and quotation of hot melt adhesives, high viscosity liquids, and fluid flow meters, please feel free to consult
Winny: sales01@cxflowmeter.com